Oldsmobile 260 V8 Horsepower

Oldsmobile 260 V8 Horsepower. Discussion starter · #3 · dec 30, 2012. I also have a 78.but when i got it the guy already swapped out the 260 for a 350 chevy out of a laguna or something it was alright but eventually i yanked the motor sent the short block to the shop for a 60 over 9.871 massage slapped on some refurbished heads and a edelbrock performer rpm intake and carb lots more power!

Ignition Distributor Oldsmobile V8 For 260 307 350 403 455 Engine 1968 from www.ebay.com

Found a 1979 oldsmobile cutlass with the 260 / auto for $700.00 and thought it might make a neat sleeper! In 1965 the 400 and 425 cid taller deck height engines were introduced. The 260 is anemic, the 307 with roller cam would waken your car up, if you can find one.

Source: www.ebay.com

The 260 was the largest oldsmobile v8 available in a cutlass. Over the years other displacements were added.

Source: www.ebay.com

In 1965 the 400 and 425 cid taller deck height engines were introduced. I hate to say this, but the best thing you could do to increase power is replace the 260 with a 350 or 403 olds engine since any small block olds will bolt right in but the exhaust manifolds may be very small on the 260.

Source: mfpclassiccars.com

I also have a 78.but when i got it the guy already swapped out the 260 for a 350 chevy out of a laguna or something it was alright but eventually i yanked the motor sent the short block to the shop for a 60 over 9.871 massage slapped on some refurbished heads and a edelbrock performer rpm intake and carb lots more power! 260 cubic inches (4.3 liters) horsepower:

Source: www.hotrod.com

See the data outlined in the table below. I hate to say this, but the best thing you could do to increase power is replace the 260 with a 350 or 403 olds engine since any small block olds will bolt right in but the exhaust manifolds may be very small on the 260.

Source: car-from-uk.com

Discussion starter · #3 · dec 30, 2012. Anyone know if you can swap a olds 4bbl 307 intake on to a olds 260 v8?

Source: www.hotrod.com

Apart from being a sensation at. Besides, the offy manifold is aluminum and looks better.

Source: www.hotrod.com

Oldsmobile produced three versions of a diesel engine between 1978 and 1985: See the data outlined in the table below.

Source: www.ebay.com

It can even do a. Anyone know if you can swap a olds 4bbl 307 intake on to a olds 260 v8?

Source: www.hotrod.com

Over the years other displacements were added. In 1964, oldsmobile came out with a new 330 cid engine.

Source: detroitdemigod.deviantart.com

Anyone know if you can swap a olds 4bbl 307 intake on to a olds 260 v8? It is almost 2 taller than the 260 / 307 / 350 and you'll have trouble closing the hood.

Source: www.ebay.ie

That's ok as i'll be installing a crate 350 in time. In 1965 the 400 and 425 cid taller deck height engines were introduced.

Source: www.youtube.com

I also have a 78.but when i got it the guy already swapped out the 260 for a 350 chevy out of a laguna or something it was alright but eventually i yanked the motor sent the short block to the shop for a 60 over 9.871 massage slapped on some refurbished heads and a edelbrock performer rpm intake and carb lots more power! Besides, the offy manifold is aluminum and looks better.

Source: www.ebay.com

Oldsmobile cutlass and cutlass supreme, delta 88, and omega. It only generated a rated 105 horsepower and 195 lb*ft of torque and produced rather leisurely performance numbers when installed in a 1981 cutlass supreme.

Source: car-from-uk.com

The 260 is anemic, the 307 with roller cam would waken your car up, if you can find one. It is almost 2 taller than the 260 / 307 / 350 and you'll have trouble closing the hood.

Source: www.ebay.com

The power is transmitted to the road by the rear wheel drive (rwd) with a. The 260 v8 was introduced in 1975 and was designed from the outset for maximum fuel.

Anyone Know If You Can Swap A Olds 4Bbl 307 Intake On To A Olds 260 V8?

I have a roller, but you would need a good block. I have 76' 260 with #10 heads and #1 iron dualjet (2bbl) intake. Apart from being a sensation at.

The 260 V8 Was Introduced In 1975 And Was Designed From The Outset For Maximum Fuel.

The 260 is a slight modification of the ford 221 windsor with more compression and bore than the 221, thereby increasing horsepower and torque. 2003 oldsmobile aurora horsepower and torque table; The power is transmitted to the road by the rear wheel drive (rwd) with a.

Now The 350 Would Let Your Cutlass Kick Serious A$$ With Either A 2 Or 4 Bbl Carb.

Besides, the offy manifold is aluminum and looks better. Antique cars classics customs hotrods leadsleds roadsters streetrods trucks turbine car 40 31 ford 67 dodge charger 61 chrysler images specs pictures photos. In 1964, oldsmobile came out with a new 330 cid engine.

See The Data Outlined In The Table Below.

Oldsmobile cutlass and cutlass supreme, delta 88, and omega. All 260s built in the us were 2 barrel carbs. Over the years other displacements were added.

260 Cubic Inches (4.3 Liters) Horsepower:

It can even do a. Found a 1979 oldsmobile cutlass with the 260 / auto for $700.00 and thought it might make a neat sleeper! The 260 is anemic, the 307 with roller cam would waken your car up, if you can find one.